Stakes

SHAPESCAPER® stakes and connectors
Manufactured in Australia with BlueScope® Steel

All SHAPESCAPER® stakes and connectors feature precision pre-drilled holes that align with corresponding holes
pre-drilled along the full length of all SHAPESCAPER® edging.
A choice of holes along each length allow for either the recommended x3 stakes per length or x4 stakes per
length for specific applications, such as long straight runs of edging in light soils or heavy traffic areas.
Lower profile stakes such as the 400mm long ribbed stake offer a choice of fastening heights that can be varied
depending on the profile of the edging being installed along with the required fastener depth.
Stakes can be installed by matching up the corresponding holes in the edging and then secured by screwing in
from the front. Alternatively stakes can be installed by screwing them in through a pre-drilled stake hole into any
part of the edging along the back face.
It is important to check that all screwed fittings are placed well under the soil level and will not cause an injury
while weeding etc. All fastening above soil level should be fitted off using the supplied rivets.